Rigol UPA-DS Power Analysis Software

699,00 (Verollinen: 866,76)

Kuvaus

Rigol UPA-DS Power Analysis Software

RIGOL UPA-DS Ultra Power Analyzer is a software of the RIGOL DS6000 series, MSO5000 series, MSO/ DS4000 series, and MSO/DS2000A series digital oscilloscopes. It can be used to analyze the Switch-Mode Power Supply (SMPS). This software can be run on Windows XP, Windows 7, Windows 8 and Windows 10 operating systems.

  • Auto calibration of channel delay
  • Power quality analysis
  • Current harmonics analysis
  • Inrush current analysis
  • Power device analysis
  • Safe operating area analysis
  • Modulation analysis
  • Output analysis
  • Offline and online working modes

Power quality analysis

The power quality characteristics of the power supply reflect the operating condition of the power supply. As the switch-mode power supply adds a nonlinear load to the mains supply, the voltage and current waveforms are different and the input current waveform would contain harmonics. This power quality measurement is required to test the power consumption and distortion on the mains supply. RIGOL Ultra Power Analyzer provides common power quality measurement.

Ultra Power Analyzer
Power quality analysis

Current harmonics analysis

The input current waveform contains harmonics. Nowadays, most of the AC-DC power supply design should conform to the IEC61000-3-2 current harmonic standard which specifies the limit of each order of harmonic for different classes of devices. Ultra Power Analyzer supports the pre-testing for all four classes of devices and the measurement of up to 40 orders of harmonics.

UPA-DS
Current harmonics analysis

Inrush current analysis

When the switch-mode power supply is turned on, the filter capacitance at the input terminal is equivalent to a transient short circuit and will generate a current with a short rise time. The inrush current function is used to analyze the poweron waveform of the switch-mode power supply.

Inrush current analysis
Inrush current analysis

Output analysis

The measurement results provide the peak-peak value, maximum, minimum as well as the frequency corresponding to the maximum amplitude in the spectrum analysis of the AC component of the output signal.

Output analysis
Output analysis

Modulation analysis

The switch power supply usually uses feedback control loop to stabilize the output voltage. The modulation analysis is mainly used to analyze the characteristics of the control loop of the switch power supply.

Modulation analysis
Modulation analysis

Safe operating area analysis

When designing the switch power supply, make sure that the switch device works in SOA (Safe Operating Area). With the SOA function, the voltage and current of the switch device are displayed in X-Y mode. You can make a pass/fail test with the specification (in X-Y mode) of the switch device as a reference.

Safe operating area analysis
Safe operating area analysis

Power device analysis

Switch loss is the most important and difficult test item in the switch-mode power supply test, because the accuracy of the measurement result can only be ensured when the real switch point is recognized. Ultra Power Analyzer allows users to set the switch level and conduction. According to these settings, the loss can be calculated accurately.

Ultra Power Analyzer
Ultra Power Analyzer: Power device analysis

Online/Offline Mode

In the online mode, it is possible to store the data in a *.csv file and to create a test report in html format. In the offline mode, waveform data can be imported and a test report in html format can also be created.

Online&Offline Mode
Online/Offline Mode

Rigol Power Analysis Software Document.pdf

Lisätiedot

Brand

Rigol

Saatat myös pitää...